HP EliteBook 8540w Mobile Workstation - Manual (Page 159)

Select To do this
Language Change the Computer Setup language.
Boot Options ● Set a Startup Menu delay (in seconds).
● Set the Multiboot Express Boot Popup delay in seconds.
● Enable/disable Custom Logo (disabled by default).
● Enable/disable Display Diagnostic URL (enabled by
default).
● Enable/disable CD-ROM boot (disabled by default).
● Enable/disable SD Card boot (enabled by default).
● Enable/disable floppy boot (enabled by default).
● Enable/disable PXE Internal NIC boot (enabled by
default).
● Enable/Disable Unified Extensible Firmware Interface
(UEFI) Boot Mode (disabled by default).
● Set the Legacy Boot Order.
Device Configurations ● Enable/disable USB legacy support (enabled by default).
When enabled, USB legacy support allows the
following:
◦ Use of a USB keyboard in Computer Setup even
when a Windows operating system is not running.
◦ Startup from bootable USB devices, including a hard
drive, diskette drive, or optical drive connected by a
USB port to the computer.
● Select a parallel port mode: ECP (Enhanced Capabilities
Port), standard, bidirectional, or EPP (Enhanced Parallel
Port).
● Enable/disable fan always on while connected to an AC
outlet (disabled by default).
● Enable/disable Data Execution Prevention (select models
only). When enabled, the processor can disable some
virus code execution, which helps to improve computer
security (disabled by default).
● SATA (Serial Advanced Technology Attachment) device
mode. The following options are available:
◦ AHCI (Advanced Host Controller Interface)
◦ IDE (Integrated Drive Electronics)
◦ RAID (Redundant Array of Independent Disks)
(select models only)
Computer Setup menus 147