HP ProLiant BL495c G6 Server-Blade - Manual (Page 28)

13. Install the heatsink. Insert both screws, and then alternate tightening until the heatsink is seated
properly.
14. Install the access panel (on page 13 ).
15. Install the server blade (" Installing a server blade " on page 17 ).
Mezzanine card option
Optional mezzanine cards are classified as Type I mezzanine cards and Type II mezzanine cards. The
card type determines where it can be installed in the server blade.
• Install Type I mezzanine cards on either mezzanine 1 connector or mezzanine 2 connector.
• Install Type II mezzanine cards only on mezzanine 2 connector.
Optional mezzanine cards enable network connectivity and provide Fibre Channel support. For
mezzanine card locations, see the system board components (on page
8 ).
For mezzanine card signal mapping, see the HP ProLiant BL495c G6 Server Blade Installation Instructions
that ship with this server blade.
To install the component:
1. Power down the server blade (on page 11 ).
2. Remove the server blade (on page 12 ).
3. Remove the access panel (on page 12 ).
Hardware options installation 28