HP ZR24w 24-inch S-IPS LCD Monitor - Manual (Page 32)

Icon Main Menu Submenu Description
Information Selects and displays important information about the
monitor.
Current Settings Provides the current input video mode.
Recommended
Settings Provides the recommended resolution mode and
refresh rate for the monitor.
Serial Number Reports the serial number of the monitor. The serial
number is needed if contacting HP technical support.
FW Version Reports the firmware version of the monitor.
Backlight Hours Reports the total hours of backlight operation.
Service Support http://www.hp.com/support
Factory Reset Returns all OSD menu settings and DDC/CI controls
to the factory default settings, except the Language.
Source Control Selects the video input signal. DisplayPort is the
factory default.
DisplayPort Selects DisplayPort as the video input signal.
DVI Selects DVI as the video input signal.
VGA Selects VGA as the video input signal.
Default Source Selects the default or primary video input signal when
the monitor is connected to two active and valid video
sources. The monitor will automatically determine the
video format. The choices are:
● DisplayPort
● DVI
● VGA
The factory default is DisplayPort.
Auto-Switch Source Turns the system's automatic video signal input to On
or Off. The factory default is On.
Source Detection This option is displayed in the OSD when a DisplayPort
input is selected. You can set Source Detection to:
● Always Active
● Low Power
The factory default is Low Power.
Exit Exits the OSD menu screen.
Table 4-2 OSD Menu (continued)
24 Chapter 4 Operating the Monitor ENWW