HP LaserJet 9050 Printer series - Manual (Page 191)

ENWW Saving resources (permanent resources) 189
Saving resources (permanent resources)
Utilities or jobs that you downloaded to the printer sometimes include resources (for example,
fonts, macros, or patterns). Resources that are internally marked as permanent remain in the
printer memory until you turn the printer off.
If you do not have an embedded or optional hard disk or flash memory card for storing
downloaded resources, you might want to change the amount of memory allocated to each
language when downloading an unusually large number of fonts, or if the printer is in a shared
environment.
The minimum amount of memory that can be allocated to resource saving is 400 KB each for
PCL and PS.
Installing EIO cards/mass storage
Hewlett-Packard constantly introduces new software tools for use with your printer and
accessories. These tools are available from the Internet free of charge. (See the HP support flyer
or go to
www.hp.com/support/lj9050_lj9040 .)
Follow this procedure to install an EIO card or mass storage device:
1 Turn off the printer and remove the power cord before installing the EIO cards or mass
storage device.
2 Use the graphic for the location of the EIO cards or optional mass storage device, such as a
hard disk.
3 Use the Device Storage Manager for Web Jetadmin to manage fonts on a mass storage
device, or use the LaserJet Utility on a Macintosh.
4 After you have installed a new device, print a configuration page by using the following
procedure.
To print a configuration page
1 Press .
2 Use or to scroll to Information and press .
3 Use or to scroll to Print Configuration and press .
EIO 1
EIO 2