HP DreamScreen 130 Wireless Connected Screen - Manual (Page 7)

HP DreamScreen User Guide 1
Getting Started
1 Attach the stand to the rear of the HP DreamScreen
by screwing it into the threaded hole in the back of
the unit. When the HP DreamScreen is in the
horizontal position, the threaded hole is at the lower
right as you face the rear of the unit.
2 Install the battery into the remote control with the
positive (+) side up.
3 Connect the power cord into the DC input of the
HP DreamScreen (1), and then plug the adapter
into an AC power outlet (2).
WARNING: When using this device, basic safety precautions should
always be followed to reduce the risk of fire, electric shock, and injury to
persons, including the following:
Do not use this product near water, for example, near a bathtub,
wash bowl, kitchen sink, or laundry tub, in a wet basement, or near a
swimming pool.
Avoid using this product during an electrical storm. There may be a
remote risk of electric shock from lightning.
NOTE: Screw in the stand by hand until it fits
snugly, but do not overtighten it.
CAUTION: Only replace the battery with
the supplied battery type.
Ensure the plus sign (+) faces up when
you install a new battery.