Connecting power, Power:connecting, Note use the power cord shipped with the jukebox – HP Optical Jukeboxes User Manual
Page 25: Turn the power on, Testing, Note if, Connecting power -13
Chapter 1
1-13
Setting Up the Jukebox
Connecting Power
Ch
ap
ter
1
: Setti
n
g
u
p
th
e Disk
Dri
v
e
S
ettin
g
u
p
th
e
Juke
b
o
x
Connecting Power
1. Ensure the power switch on the jukebox is OFF (see Figure 1-1).)
NOTE
Use the power cord shipped with the jukebox.
2. Plug the socket end of the power cord into the power port on the bottom of the
interface enclosure (see “8” on Figure 1-2).
3. Plug the other end of the power cord into a power outlet.
4.
(After the jukebox is moved to its operating location) Lower the leveler feet and
tighten the 1/2-inch nut on each foot.
5. Turn the power on.
TESTING
and NOT READY alternately display. Once the poweron test
completes (approximately 1.5 minutes), READY displays.
NOTE
If DEVICE FAILED displays. See “Troubleshooting” in Chapter 3 for
troubleshooting procedures.
NOTE
Go to “Configuring Write Verify” on the next page to complete the installation.