HP XP P9500 Storage - Manual (Page 446)

The installhdlm Utility for Installing HDLM
You can use the installhdlm utility to perform a new installation, upgrade
installation, or re-installation of HDLM in unattended installation mode. You
must predefine how the utility is to respond during installation in the
installation-information settings file.
Solaris 11 has functionality to create a new boot environment.HDLM,
however, can be installed only in the current boot environment.
For details on the procedure for performing an unattended installation, see
Performing a New Installation of HDLM (When Sun Cluster Is Not Being Used)
on page 3-55 , Performing a New Installation of HDLM (When Sun Cluster Is
Being Used) on page 3-62 , or Performing an Upgrade Installation or Re-
installation of HDLM on page 3-73 .
Format
/directory-where-DVD-ROM-is-mounted/HDLM_Solaris/installhdlm [ -f
installation-information-settings-file-name | -h]
Parameters
If you do not specify the -f or -h parameter, installation can be performed by
the pkgadd or pkg install command.
-f installation-settings-file-name
Defines the information required to perform an installation.
For details on the installation-information settings file, see
Contents of the
Installation-Information Settings File on page 7-32 .
-h
Displays help about the usage of the command.
Contents of the Installation-Information Settings File
The following describes the contents of the installation-information settings
file.
[INSTALLATION_SETTINGS] section
This section defines operation information for the installhdlm utility. The
[INSTALLATION_SETTINGS] section must be specified first in the installation-
information settings file. However, this section may be preceded by a blank
line or comment line.
The following table describes the keys to be defined in the
[INSTALLATION_SETTINGS] section.
7-32
Utility Reference
Hitachi Dynamic Link Manager User Guide for Solaris ®