HP LaserJet P2015 - Manual (Page 94)

The printer driver does not automatically set up your selected printer in the Print Center or Printer Setup Utility.
Cause Solution
The PostScript Printer Description (PPD) file is corrupt. Delete the PPD file from the following hard-drive folder: Library/
Printers/PPDs/Contents/Resources/<lang>.lproj,
where <lang> is the two-letter language code for the language that
you are using. Reinstall the software. See the Getting Started
Guide for instructions.
The printer might not be ready. Make sure that the cables are connected correctly, the printer is on,
and the ready light is on. If you are connecting through a USB or
Ethernet hub, try connecting directly to the computer or use a different
port.
The interface cable might be defective or of poor quality. Replace the interface cable. Make sure to use a high-quality cable.
A print job was not sent to the printer that you wanted.
Cause Solution
The print queue might be stopped. Restart the print queue. Open print monitor and select Start Jobs.
The wrong printer name or IP address is being used. Another printer
with the same or similar name, IP address, or Rendezvous or Bonjour
host name might have received your print job. Print a configuration page to check the printer name, IP address, or
Rendezvous or Bonjour host name. Verify that the name, IP address,
or Rendezvous or Bonjour host name on the configuration page
matches the printer name, IP address, or Rendezvous or Bonjour
host name in the Print Center or Printer Setup Utility.
You are unable to print from a third-party USB card.
Cause Solution
This error occurs when the software for USB printers is not
installed. When adding a third-party USB card, you might need the Apple USB
Adapter Card Support software. The most current version of this
software is available from the Apple Web site.
When connected with a USB cable, the printer does not appear in the Print Center or Printer Setup Utility after the driver is selected.
Cause Solution
This problem is caused by either a software or a hardware
component. Software troubleshooting
● Check that your Macintosh supports USB.
● Verify that your Macintosh operating system is Mac OS X v10.2
or later.
● Ensure that your Macintosh has the appropriate USB software
from Apple.
Hardware troubleshooting
● Check that the printer is turned on.
● Verify that the USB cable is connected correctly.
● Check that you are using the appropriate high-speed USB cable.
Table 7-4 Problems with Mac OS X (continued)
84 Chapter 7 Problem solving ENWW