HP Insight Management-Software - Manual (Page 44)

set iscsi-connection
The –set iscsi-connection command modifies the properties of a specified iSCSI connection.
Syntax
-set iscsi-connection –profilename <profileName>
-portnumber <PortNumber>
[-network <Network Name>]
[-speedtype <auto|preferred|custom>]
[–speed <speed>]
Parameters
Table 18 Parameter descriptions for –set iscsi-connection
Optional Required Description Parameter
x The profile for the
iscsi-connection -profilename
x The port number for the
isci-connection. -portnumber
x The name of an existing
network to associate with the -network
connection. If the network
name is not specified the
network is unassigned and
can be assigned later.
x The requested operational
speed for the server port. -speedtype
Valid values include auto,
preferred
and custom.
The default value is
preferred
. The following
list describes the speed type:
• Auto—Allocates
maximum port speed
constrained by the
maximum configured
speed for the network
• Preferred—Speed of the
network matches the
preferred speed of the
network to which the
connection is associated.
NOTE: If no preferred
speed is configured, the
network speed defaults to
auto
.
•
Custom—Configures any
speed from 100Mb to the
maximum configured
speed for the network in
100Mb increments.
x
NOTE: The parameter
-speed is required if
speed type is set to
custom .
The user-defined speed for
a server port. Valid values
include 100Mb to the
maximum configured speed
for the network in 100Mb
increments. The acceptable -speed
value is 100Mb to the
maximum.
44 Using VCEM commands