HP Integrity NonStop J-Series - Manual (Page 84)

Working With SAFECOM
Safeguard User’s Guide — 422089-020
7 - 14
Error Handling in Command Files
which a batch operation uses the command file $system.mgr.tight to set up current
default values for disk-file attributes:
Only three commands are entered interactively: VOLUME, OBEY, and ADD. The
VOLUME command sets the default volume and subvolume. OBEY executes the
commands stored in $system.mgr.tight. The ADD command adds a disk file to the
Safeguard database and gives it the security settings set up in $system.mgr.tight.
Error Handling in Command Files
When SAFECOM encounters an error while processing a command file, it redisplays
the erroneous command and displays an error or warning message describing the
nature of the error.
If it is a syntax error, then SAFECOM aborts the processing and causes ABEND. If the
error does not cause the OBEY processing to abort, SAFECOM continues processing
the command file and causes ABEND at the end. As a result, TACL returns -6 as the
MESSAGECODE and a non-zero value as the COMPLETIONCODE.
SAFECOM error and warning messages are described in the Safeguard Reference
Manual.
=VOLUME $system.mgr
=OBEY tight
=ASSUME DISKFILE -- Build default ACL for DISKFILE
.
.
.
=SHOW -- Display current defaults
TYPE OWNER
DISKFILE 255,8
OBJECT-TEXT-DESCRIPTION=
AUDIT-ACCESS-PASS = NONE AUDIT-MANAGE-PASS = NONE
AUDIT-ACCESS-FAIL = ALL AUDIT-MANAGE-FAIL = NONE
LICENSE = OFF PROGID = OFF CLEARONPURGE = OFF PERSISTENT = OFF
TRUST = OFF
003,255 R
255,008 R,W,E,P
255,254 R,W
=ADD $data.sales3.q3report
Note. ABEND (on any error while processing either OBEY file or IN file) is supported only on
systems running H06.28 and later H-series RVUs and J06.17 and later J-series RVUs.