Actions, Switch-to-node pic – HP NonStop G-Series User Manual
Page 257
Presence
Whether the Power Supply is installed and responding.
Values: Present, Absent, Unknown
LED State
The state of the fault LED on the power supply.
Values: On, Off, Blinking
Track ID
The track ID of the power supply.
Manufacturer
Identifies the manufacturer of the component.
Hardware Revision The hardware revision of the power supply.
Logical
Enabled State
The initial state of the component at the time of discovery.
Enabled: The component is operational.
Disabled: The component is present but not operational.
Device State
Whether the power supply has a fault.
Values: OK, Fault
Actions
Blink LED Off
Turns off the blinking of the LEDs.
Blink LED On
Causes the LEDs to blink on and off.
Switch-to-Node PIC
that connects to a ServerNet node. The last
part of the name contains the port number where the PIC is located. Only the PICs in ports 0
through 7 of the switch are used for switch-to-node connections.
Location in OSM tree: External ServerNet Fabric > Switch Group > Switch Module > Switch
> Switch PIC
Example: Switch PIC $ZZSMN.X2.4 (indicates the PIC in port 4 of switch X2)