HP Officejet Pro 8500A - Manual (Page 32)

To connect a storage device
1. If you are connecting a digital camera, change the USB mode of the camera to
storage mode, and then connect one end of the USB cable to the camera.
NOTE: Different cameras use different terms to describe the storage mode.
For instance, some cameras have a digital camera setting and a disk drive
setting. In this instance, the disk drive setting is the storage mode setting. If
storage mode does not work on your camera, you might need to upgrade the
camera firmware. For more information, see the documentation that came with
the camera.
2. Insert the USB storage device or the other end of the camera’s USB cable to the
USB port on the front of the printer.
NOTE: If your USB device does not fit into this port due to size limitations, or if
the connector on the device is shorter than 11 mm (0.43 in), you will need to
purchase a USB extension cable in order to use your device with this port. For
more information on supported USB devices, see Memory card specifications.
Install the accessories
This section contains the following topics:
• Install the duplexer
• Install Tray 2
• Turn on accessories in the printer driver
Chapter 1
28 Get started