HP XP Racks - Manual (Page 167)

Configuring fibre channel ports
Setting the data transfer speed on a fibre channel port
The Storage Administrator (Provisioning) role is required to perform this task.
As system operation continues, you might notice that a large amount of data is transferred at some
ports, but a small amount of data is transferred at other ports. You can optimize system performance
on a fibre channel port by setting a faster data transfer speed on ports where a larger amount of
data is transferred, and setting a slower data transfer speed on ports where a smaller amount of
data is transferred.
Procedure 16 To set the data transfer speed on a fibre channel port
1. In the Storage Systems tree, click Ports/Host Groups.
2. In the Ports/Host Groups window, select the Ports tab.
3. Select the desired port.
4. Click Edit Ports.
5. In the Edit Ports window, select the Port Speed check box, and then select the desired port
speed.
Select the speed of the fibre channel port in the unit of Gbps (Gigabit per second). If Auto is
selected, the storage system automatically sets the speed to 2, 4, 8, or 16 Gbps.
CAUTION: Observe the following cautions when setting speed on a fibre channel port:
•
If the HBAs (host bus adapters) and switches support 2 Gbps, use the fixed speed of 2
Gbps for the CHF (channel adapter for fibre channel) port speed. If they support 4, 8,
or 16 Gbps, use 4, 8, or 16 Gbps for the CHF port speed, respectively.
•
If the Auto Negotiation setting is required, some links might not be up when the server is
restarted. Check the channel lamp. If it is flashing, disconnect the cable, and then reconnect
it to recover from the link-down state.
•
If the CHF port speed is set to Auto, some equipment might not be able to transfer data
at the maximum speed.
•
When you start a storage system, HBA, or switch, check the host speed appearing in the
Port list. If the transfer speed is different from the maximum speed, select the maximum
speed from the list on the right, or disconnect, and then reconnect the cable.
6. Click Finish.
7. In the Confirm window, confirm the settings, in Task Name type a unique name for this task
or accept the default, and then click Apply.
If Go to tasks window for status is checked, the Tasks window opens.
Setting the fibre channel port address
The Storage Administrator (Provisioning) role is required to perform this task.
When configuring your storage system, set addresses for fibre channel ports. When addressing
fibre channel ports, use AL-PA (arbitrated-loop physical address) or loop IDs as the addresses. See
“Addresses for fibre channel ports” (page 168) for information about available addresses.
1. In the Storage Systems tree, click Ports/Host Groups.
2. In the Ports/Host Groups window, select the Ports tab.
3. Select the desired port.
4. Select Edit Ports.
5. In the Edit Ports window, select the Address (Loop ID) check box, and then select the address.
6. Click Finish.
Configuring fibre channel ports 167