1 preparing to configure, Prerequisites – HP 3PAR Operating System Software User Manual
Page 8
1 Preparing to Configure
Prerequisites
IMPORTANT:
Before using SmartStart to configure your system, you must complete the setup tasks
detailed in the appropriate installation guide. Go to the HP Support Center:
•
•
A DHCP network is no longer required to set up a virtual Service Processor (
). For more
information about how to manually set the VSP IP address when DHCP is not available, see the
HP 3PAR StoreServ 7000 Storage Installation Guide.
NOTE:
The
and storage system must be on the same subnet.
Before you configure your new HP 3PAR StoreServ 7000 Storage system:
•
Verify that the following setup tasks are complete, as described in the HP 3PAR StoreServ
7000 Storage Installation Guide:
◦
All components are installed.
◦
If you are using a
, the system time is set to the correct time of day on the ESXi host.
8
Preparing to Configure