GE JV566HSS - Manual (Page 11)

11
REMOVE DUCT KNOCKOUT(S)
If recirculating, non-vented ductless (optional for
JV5 Series models only), see note below and skip to
Step 9 D and proceed. The JV6 Series models cannot be
recirculated.
Using a flat blade screwdriver, remove the appropriate
duct knockout(s) from the top or back of the hood.
3 1 ø 4
” x 10” Rectangular
vertical discharge.
Remove top rectangular
duct knockout only.
” Round vertical discharge.
Remove semi-circular duct
knockout and top rectangular
duct knockout.
3 1 ø 4
” x 10” Rectangular horizontal
discharge. Remove rear
rectangular duct knockout only.
FOR 3 1 ø
4
” x 10” RECTANGULAR
DUCTED DISCHARGE INSTALLATIONS
ONLY:
Attach H[KDXVWDGDSWRUGDPSHU over knockout
RSHQLQJZLWKWZRH[KDXVWDGDSWRUVFUHZV0DNHVXUH
damper pivot is nearest to WRSEDFNHGJH of hood.
Remove tape from damper flap.
Up to 1” side-to-
side adjustment
Tape
Top/back edge
([KDXVWDGDSWRUGDPSHU
(vertical discharge
position shown)
Pivot
)25” ROUND VERTICAL DUCTED
DISCHARGE INSTALLATIONS ONLY:
 5HLQVWDOOWKH” round exhaust adaptor with its
screws, removed in Step 2 under the “Prepare the
Hood” section.
6 
8
” round
H[KDXVW
adaptor
NOTE:7KH”URXQGH[KDXVWDGDSWRUFDQEHLQVWDOOHG
up to 1 inch on either side of the hood center to
DFFRPPRGDWHRIIFHQWHUGXFWZRUN,QH[WUHPHRIIFHQWHU
installations, one end of the duct connector may need
to be trimmed to clear the electrical cable clamp.
127( 7KH” round damper is not included with
this product. It can be purchased as a kit by calling
800.626.2002. Order kit number JXDA22.
Installation Instructions
NOTE: 7KHH[KDXVWDGDSWRUGDPSHUFDQEHLQVWDOOHG
up to 1 inch on either side of the hood center to
DFFRPPRGDWHRIIFHQWHUGXFWZRUN,QH[WUHPHRIIFHQWHU
installations, one end of the duct connector may need to
be trimmed to clear the electrical cable clamp.
NOTE: If the hood is to be installed in a recirculating, non-
vented ductless manner, order charcoal filters,
NLWQXPEHU:%;IRU
” hood models, or
NLWQXPEHU:%;IRU ” hood models.
These kits can be ordered from your GE supplier.
Skip to Step 9 D and proceed.