Aga Ranges LEGACY 36 F104650-01 - Manual (Page 9)

9
SERVICING - WARNING
Disconnect from electricity and gas before servicing. Check appliance is safe when you have finished.
19. To Change Ignition Generator
Disconnect from electricity supply.
Pull cooker forward to gain access to the cover
box at the rear of the left hand cooker. Remove
the screws securing the cover and lift clear.
Pull off all the leads to the generator noting
their positions. Slacken the two screws holding
generator to cooker and remove generator.
Fit new generator to cooker and replace leads.
Reassemble in reverse order. Refer to wiring
diagram. Check ignition performance.
20. To Remove Oven Inner Back.
Open the oven door. Remove oven furniture. For
the LH oven unscrew the 2 thermostat phial fi xing
screws.
Remove the fi xings that secure the inner back to
the oven rear.
Lift the removable panel away. Re-assemble in
reverse order. Ensure that the retaining fi xings
are fully tightened. For the LH oven unscrew the
2 thermostat phial fi xing screws. Remove the
screws that secure the inner back to the oven rear.
Lift the removable panel away. Re-assemble in
reverse order. Ensure that the retaining fi xings are
fully tightened.
22. To Replace an Oven Fan
Disconnect from electricity supply.
Pull the unit forward to access the cover boxes at
the rear of the appliance.
Remove the fi xings that secure the cover and
lift it clear. Remove the fan wiring, noting the
connection positions. Remove the inner back as
detailed in Section 20. Hold the fan blades and
undo the centre nut (LH thread), brass washers
and fan blade. Undo the fi xings that retain the
fan and remove it from the cavity rear. Fit the
replacement and re-assemble parts in reverse
order. Check that the oven operates satisfactorily.
23. To Remove an Oven fan Element
Disconnect from electricity supply.
Remove the inner back as detailed in Section 20.
Remove the fi xings that secure the element
within the oven and lift the element away
carefully. Disconnect the leads and connect to
the replacement element and re-assemble parts
in reverse order. Check that the oven operates
correctly.
24. To Remove Broiler Element.
Disconnect from electricity supply.
Remove broiler pan from broiler chamber. From
inside broiler compartment remove enamelled
front shield from broiler roof, 2 screws and
washers. Remove 2 screws and washers securing
the broiler element front support. Remove 1 screw
from each of the broiler elements and withdraw
broiler elements from broiler chamber. Disconnect
the leads and connect to the replacement
elements and re-assemble parts in reverse order.
Check operation of broiler.