GE GTDS850GDWS - Manual (Page 14)

Installation Instructions
14
13
2
1 Open the door to approximately 170 degrees.
With a putty knife, remove the 4 plastic covers located
along the left side of front panel and set them aside.
Remove the bottom screw from each hinge (right side)
and partially insert the, into the top left side hinge holes.
NOTE: All 4 front panel hinge screws will now be in the
top hinge holes - 2 on the left and 2 on the right.
Plastic Cap (4)
3 Loosen the bottom 2 right side hinge screws. Remove
WKHGRRUDQGSODFHLWRQDSURWHFWHGÀDWVXUIDFHWRDYRLG
any damage. Remove both the Blind Plate and the Strike
Plate and install them in opposite positions.
4
Remove the 4 door hinge screws, 8 edge screws, and 4
LQVLGHVFUHZV/LIWWKHLQQHUGRRUXSZDUGVXVLQJDÀDW
blade screwdriver.
REVERSING THE DOOR SWING
SOLID DOOR MODELS
WITH COVER CAPS: