GE ZV850SPSS - Manual (Page 5)

Care and Cleaning
Stainless Steel Hood
Metal
grease
filter
Clean the grease filter after 30 hours of “on” time.
A signal light will alert you when 30 hours has
passed.
Remove the grease filters and wash them either
by hand or in the dishwasher using non-abrasive
soap.
To clean, swish the filters in hot, soapy water or
wash them in the dishwasher. Do not use abrasive
cleansers.
Hood
surfaces
Do not use a steel-wool pad; it will scratch
the surface.
To clean the stainless steel surface, use warm,
sudsy water or a stainless steel cleaner or polish.
Always wipe the surface in the direction of the
grain.
Follow the cleaner instructions for cleaning
the stainless steel surface. To inquire about
purchasing stainless steel appliance cleaner or
polish or to find the location of a dealer nearest
you, please call our toll-free number:
National Parts Center:
800.626.2002
NOTE: To remove
filters, push them
back and down
using the knob.
For proper operation, be sure
to use the lower set of filter
holders.
Front
Charcoal
filters
(on some models)
If the model is not vented to the outside, the air
will be recirculated through disposable charcoal
filters that help remove smoke and odors.
The charcoal filters should be replaced when
they are noticeably dirty or discolored (usually
after 6 to 12 months, depending on hood usage).
NOTE: DO NOT rinse, or put charcoal filters in an
automatic dishwasher.
The charcoal filters cannot be cleaned.
They must be replaced.
Order Charcoal Filter Kit (3 filters) WB02X10731.
This kit can be ordered from your GE Supplier.
NOTE: To remove the metal
filters, push them back and
down using the knob. Push
the charcoal filters back
and down using the tab.
Front
For proper operation, be sure to use
the charcoal filters in the upper set of
filter holders and metal filters in the
lower set of filter holders.
Metal Filters
Charcoal Filters
5
For your
safety
Before servicing or cleaning the unit, switch
power off at the service panel and lock the service
panel to prevent power from being switched on
accidentally. If the service panel cannot be locked,
fasten a tag or prominent warning label to the
panel.