Alpine IVA-C801 - Manual (Page 35)

33
-EN
→
→
→
→
→
→
Adjusting Levels
1
Press and hold the FUNC (RETURN) button for
at least 2 seconds in the Divider mode.
The mode changes to the Divider Adjustment
mode.
2
Press the 2 (LEVEL) button. The mode changes
to the Level Adjustment mode.
3
Press the rotary encoder and select the channel
you wish to adjust.
Each press changes the channels as follows:
When only one 2-way system divider is
connected:
→ L-Low → R-Low → F-High/L
R-High/R ← R-High/L ← F-High/R ←
When two 2-way system dividers are
connected:
→ L-Low → R-Low → L-High → R-High
Each time the 6 (F/R) button is pressed,
the mode switches between the Front
adjustment, and Rear adjustment modes,
and the display also changes.
→ L-Low → R-Low → L-High → R-High
When only one 3-way divider is connected:
→ L-Low → R-Low → L-Mid → R-Mid → L-High → R-High
When two 3-way dividers are connected:
→ L-Low → R-Low → L-Mid → R-Mid → L-High → R-High
Each time the 6 (F/R) button is pressed,
the mode switches between the Front
adjustment and Rear adjustment modes,
and the display also changes.
→ L-Low → R-Low → L-Mid → R-Mid → L-High → R-High
4
Rotate the rotary encoder clockwise or
counterclockwise to adjust to your desired level
upward or downward respectively.
5
When adjustments have been completed, press
the
FUNC (RETURN) button.
The display returns to the Divider mode.
→
→
6
Press the rotary encoder and select the channel
that you wish to adjust.
Each press changes the channel as follows.
When only one 2-way divider is connected:
→ Low → F-High → R-High
When two 2-way dividers are connected:
→ Low → High
Each time the 6 (F/R) button is pressed,
the mode switches between the Front
adjustment and Rear adjustment modes,
and the display also changes.
→ Low → High
When only one 3-way divider is connected:
→ Low → Mid-L → Mid-H → High
When two 3-way dividers are connected:
→ Low → Mid-L → Mid-H → High
Each time the 6 (F/R) button is pressed,
the mode switches between the Front
adjustment and Rear adjustment, and the
display also changes.
→ Low → Mid-L → Mid-H → High
7
Rotate the rotary encoder clockwise or
counterclockwise to adjust the Cross-Over point
upward or downward to your desired point.
8
When the adjustment has been completed, press
the
FUNC (RETURN) button. The display returns
to the Divider mode screen.