American Audio DCD PRO 250 - Manual (Page 10)

American DJ
®
AUDIO • DCD-PRO250™ INSTRUCTIONS MANUAL • PAGE 10
player 1 connector on transport assembly.
4) PLAYER 1 CONTROL - Connect mini-plug from
CONTROL out on rear of CONTROL UNIT to a
mixer’s CONTROL out. This feature is available on
all mixers with Fader “Q” Start (see Q” Start
Control p.5).
D. LCD (Figure 5)
1) TRACK INDICATOR - Indicates the current track
that is playing, cued, or in pause mode.
2) MINUTES INDICATOR - Display current minutes of
the track.
3) SECONDS INDICATOR - Displays the tracks
current seconds.
4) FRAME INDICATOR - Displays current track
frame.
5) BAR INDICATOR - These ten indicator provide a
FUNCTIONS & CONTROLS CONT.
visual display of the approximate position of the
pickup within the current track.
6) ELAPSED INDICATOR - It indicates that the time
shown on the display is the elapsed time.
7) CONTINUE INDICATOR - When this indicator is
glowing, disc playback will continue through the
remain tracks until the disc ends.
8) SINGLE INDICATOR - When this indicator is
glowing, playback on the current track will stop at
the beginning of the next track.
9) REMAIN INDICATOR - It indicates that the time
shown on the display is the remaining time of the
playing track.
10) PITCH PERCENTAGE DISPLAY - This displays
the amount of pitch being applied to the current
track. The pitch percentage is adjusted by the
PITCH SLIDER.
1. Opening and Closing the Disc Holder
• Turn the unit power on. Press the OPEN/CLOSE button to open or close the disc tray. OPEN/
CLOSE buttons are provided on both the main unit and control unit.
• The disc holder cannot be opened during playback. This feature is to prevent playback from being
interrupted if the OPEN/CLOSE button is pressed accidentally. Stop playback first, then press the
OPEN/CLOSE button.
2. Loading discs
• Hold the disc by the edges and place it in the disc holder, then press the OPEN/CLOSE button again to
close the disc holder. The unit will show the track number and the total playing time for about 2 seconds
then enter the cue condition, the cue point will be set to the music starting point of the first track
automatically.
BASIC OPERATIONS
5 in. / 12cm disk 3 in. / 8cm disk
Fig. 8 Fig. 9