Approach Tech NVR-2018 - Manual (Page 39)

37
AUDIO ENABLE:
(1) Press the Setup button to enter the MAIN MENU .
(2) Select the item termed " LAN CAMERA " and press the Enter button to enter the
LANCAM SETTING page.
(3) Select the item termed " AUDIO ENABLE " and push the Enter button to select the
AUDIO ENABLE .
(4) To activate the motion detection function, set " AUDIO ENABLE " to " ON ". To deactivate the
function, set " AUDIO ENABLE " to " OFF " The items termed " OFF " and " ON " switch all the
channels in the AUDIO ENABLE SETTING page off and on respectively as well. If you wish
to select individual channels for sounds, select the item termed " SET " and activates your
desired channels by pressing them " ON " while turning the rest " OFF ". After set individual
channels in different modes and then push the Enter button . At once the legends " OK "
and " CANCEL " appear at the bottom of the page. Now press the “ < ” button and the “ > ”
button to confirm either " OK " or " CANCEL " respectively. Press " OK " to ratify your
choice(s). If not, press " CANCEL ".
MAIN MENU
LAN CAMERA
RECORD / BANDWIDTH
CLOCK / TIMER / SEQ
ALARM
COMMUNICATION
DISK
SYSTEM
LANCAM SETTING
LANCAM SETTING
IP / ACCOUNT
: SET
IMAGE : SET
AUDIO ENABLE : OFF
MOTION : OFF
MAIN PAGE
SET AUDIO ENABLE
LANCAM SETTING
AUDIO ENABLE : OFF
ON
SET
MAIN PAGE
SET AUDIO ON/OFF INDIVIDUALLY
AUDIO ENABLE SETTING
CH1 CH2 CH3 CH4
OFF OFF OFF OFF
CH5 CH6 CH7 CH8
OFF OFF OFF OFF
OK CANCEL