American Fibertek Net I/O N-111 - Manual (Page 17)

17
Reset sequence
If the IP address or username and password to log in are not know, it will be necessary
to reset the N-111 to factory defaults in order to access the administration web interface.
The reset procedure will set all unit settings to their factory defaults.
To reset the N-111 perform the following steps:
Disconnect power from the N-111
With a paperclip or other small object, press and hold the reset button recessed
in the rear of the unit
Connect power to the N-111
Wait for the LED test sequence to complete
Release the reset button
The N-111 will now be reset to factory default configuration. This will reset all user-
configurable settings, including network address, username and password, and all
contact and serial interface settings.