Ashland I-110TS2 ver 1111 - Manual (Page 30)

ASHLAND SCRAPERS
Torque Specifications
TORQUE
SPECIFICATIONS
LUBRICATION
1. Grease all zerks every 8 hrs of operation with high quality, general-purpose
grease.
a) Grease until grease flows from around pin.
Lubrication Points (see Ill.)
1. Hitch – Horizontal and vertical pins.
2. Lift Cylinders – Rod end &Trunion; Both left & right sides.
3. Front Arm Pivot Joint – Both left & right sides.
4. Apron Cylinders – Rod clevis pin; Both left & right sides.
5. Apron Pivot Pin – Both left & right sides.
6. Hold-down Rollers – Both left & right sides.
7. Floor Rollers – Both left & right sides.
8. Tapered Rollers – Both left & right sides.
Bolt Torque
Diameter Ft-lbs
1/4 12
5/16” 25
3/8” 45
7/16” 70
½” 110
9/16” 150
5/8” 220
¾” 380
7/8” 600
1” 900
1-1/8” 1280
Lug Nuts 85-100 /9 yd 450- 11/13 yd 750-15 yd & up
PHONE : 715-682-4622 Fax: 715-682-9717
P.O. Box 717
1115 Rail Dr Ashland , WI 54806 Page #29