BMR Suspension DTB003 - Manual

DRIVESHAFT TUNNEL BRACE
DTB003 – 1967-1969 Camaro and Firebird Convertible
Tools required:
o
3/8” drive ratchet
o
9/16” socket
o
5/16” Allen wrench
Installation:
1. Lift the vehicle high enough to gain access
to the driveshaft tunnel area. Support with
jack stands.
2. Using the 9/16” socket, remove the six bolts
holding the OE tunnel brace in place.
Remove.
3. Position the BMR tunnel brace into place
and install the provided 3/8” Allen bolts with
washers.
4. Torque bolts to 40 ft/lbs.
5. Lower vehicle.
ABOVE IMAGE SHOWN WITH OPTIONAL 6 SPEED CROSSMEMBER.
WWW.BMRFABRICATION.COM
This product is an aftermarket accessory and not designed by the vehicles manufacturer for use on this vehicle. As such, buyer
assumes all risk of any damage caused to the vehicle/person during installation or use of this product.