BMR Suspension DSL017 - Manual (Page 2)

DRIVESHAFT SAFETY LOOP INSTALLATION (Continued)
7. Thread the supplied half nuts and lock washers onto the exposed threads of the transmission mount then tighten to 25 ft/lbs .
8. Install the driveshaft loop by positioning it over the small diameter portion of the driveshaft as in IMAGE 5. Once positioned
insert the supplied 3/8” bolts through the (4) holes. Center the loop over the driveshaft then place a washer and nut on the
bottom side of each bolt. Tighten to 40 ft/lbs. See IMAGE 6. NOTE: if using an aftermarket one-piece driveshaft, it may
be necessary to shim the loop for adequate driveshaft clearance.
9. Lower vehicle.
WWW.BMRFABRICATION.COM
2
This product is an aftermarket accessory and not designed by the vehicles manufacturer for use on this vehicle. As such, buyer assumes all risk of
any damage caused to vehicle/person during installation or use of this product.