BMR Suspension BK005 - Manual (Page 2)

Rear Upper Control Arm Bushing
BK005 (Continued)
6. Using a 15mm socket, remove the 4 front flange bolts on the exhaust (2 per side).
See Image 5.
7. Remove center 15mm exhaust hanger bolt in rear. See Image 6.
8. Using a helper, remove the entire exhaust assembly.
9. Using a 10mm socket, remove the front driveshaft tunnel exhaust shield. See
Image 7 above.
10. Using an 18mm wrench and socket, remove the 3 bolts that connect the driveshaft
flex joint to the differential. See Image 8 above. NOTE: Remove the appropriate
bolts so that the rubber flex joint remains attached to the driveshaft, NOT the
differential. Using a pry-bar, pry the joint off the alignment dowel (Image 9
below).
11. Un-plug the fuel pump wiring harness located on the passenger side of the car
next to the front cradle bushing. See Image 10 below.
12. Support the cradle with a hydraulic jack or adjustable frame stands.
2
13.
14.
15.
16.