Clinton Electronics CE-T909 - Manual (Page 2)

OSD CONNECTION
ZOOM
5. CAMERA ADJUSTMENT
a.
Camera plate rotation can be adjusted by turning the camera to the desired location.
SET SCREW
360°
180°
c.
Barrel rotation can be adjusted by rotating the camera body to the desired location.
b.
Lens angle can be adjusted by tilting to the desired location.
d.
After camera adjustments have been made, tighten the set screw to lock in
adjustments.
Take notice of location of cable exiting the back of the camera body. Depending on angle
of lens there is potential for stretching or pinching of cable. Rotate camera body or outer
plate as necessary.
6. REMOTE CONTROL 7. ZOOM/FOCUS ADJUSTMENT
To test the camera with a test monitor first remove the cap located on the underside of
the camera. Plug the *CE-REMOTE into the OSD connection, and connect your test
monitor to the BNC connection located on the *CE-REMOTE cable.
Refer to OSD Manual for detailed instructions on adjusting camera settings.
*CE-REMOTE sold separately.
To adjust the zoom or focus of the camera, first loosen the appropriate set screw with the
supplied Allen wrench.
To widen the viewing angle, rotate the Zoom collar to the Left. To narrow the viewing
angle rotate the ZOOM collar to the Right. Rotate the Focus collar Left or Right to focus
the lens.
FOCUS
After adjustments have been made tighten the Allen screws to lock the adjustments into
place and replace the cap on the underside of the camera.
SET SCREW
360°
v.05.29.13
*Information in this document is subject to change
Clinton Electronics