Cyron Lighting HTW310RF RGB - Manual (Page 3)

HTW310RF operates on fully regulated 12VDC power. The size (wattage) of the power supply
depends on the number of lights being used. Refer to Table One for calculating the power supply
ratings. 12VDC can be supplied via the DC jack on the side or the terminal blocks as shown in
the wiring diagram. It is not recommended to use the DC jack if you are supplying more than 6A
current or 72W power.
CYRON
Series/Size Watts per one
lightbar Model numbers available
(Qty) LEDs per bar / Type
of LED
HT (Standard) / 9” 1.44 HTB9 (2x9”) 18 / Superbright 60º
HT (Standard) / 15” 2.40 HTB15 (2x15”)
HTB15-B10 (10x15”)
HTB15-5B10 (10x15”) 5ft
cords 30 / Superbright 60º
HTP (Pro) / 9” 1.20 HTPB9 (2x9”)
<limited qty> 15 / Ultrabright SMD
120º
HTP (Pro) / 15” 2.16 HTPB15 (2x15”) 27 / Ultrabright SMD
120º
HTP (Pro) / 24” 3.60 HTPB24 (2x24”) 45 / Ultrabright SMD
120º
HTPR / 12” 2.20 HTPR-F 9 / Tri-chip
SMD 120º
HTPR / 16.5feet 36.00 HTPB-RL 150 / Tri-chip
SMD 120º
__________ Table One __________
a
Do not mix different types of CYRON lightbars “HT” and “HTP” series in one area as this
will cause inconsistency in colors.
a
IMPORTANT: Do not short out the output wires. Controller will be damaged.
Note: The hardwiring diagram for CYRON “HT” and “HTP” models can be requested by
sending email to [email protected].
Operations _____
Place the battery in the remote control. Press any button and make
sure the indicator light turns on. Check the battery if it does not.
Remote Buttons:
ON/OFF: Turns lights on and off.
MODE: Cycles through 21 modes as listed in chart below