Cyron Lighting HTW1000 RGB - Manual (Page 4)

a
Do not mix different types of CYRON lightbars in one area as
this will cause inconsistent colors. Color convergence of “HT” products
is different than HTP series.
There are two methods of connecting lights to the controller:
1. PLUG-n-PLAY lightbar connection
Connect the lightbars to controller plugs. Pay attention to the polarity
of the plugs. Do not use excessive force. The order in which they get
connected does not matter. You can plug as few as one or as many as
twelve. Use zip ties or other means to secure the wires together. This
will prevent the lightbar plugs from accidentally disconnecting.
CYRON supplies hub extender (part# HTH61) which provides 5 more
outlets for a total of 17 lightbars.
2. HARDWIRING Connecting more than 12 CYRON lightbars
You may choose this option if you are connecting more than 12
lightbars (17 with hub extender) or if lightbar cords are too short for
your project.
Hardwiring needs ample knowledge of wiring practices. This
option should be done by experienced professionals such as electricians
or certified custom electronic installers. Please contact CYRON
Technical Support for further details. There may be other options
available for your project. CYRON experienced Tech Support staff will
be happy to help you implement your project.
The hardwiring diagram can be requested by sending email to
[email protected].
Operations _____
The HTW1000 remote allows the ultimate control of the full color
spectrum. It has many features which may take some time to get
familiar with.
Power, Turn on
Power, Turn off
Pre-programmed Light show: Sequentially turns on/off seven
preset colors (colors cannot be changed).
Pre-programmed Light show: Color Transition. Gradually
changes color of light thru a preset color sequence.