Equus 3130 - Scan Tool – OBD2 - Manual (Page 48)

Additional Tests
NON-CONTINUOUS TEST
46 OBD2
E
NON-CONTINUOUS TEST
The Non-Continuous Test function retrieves and displays test results
for emission-related powertrain components and systems that are not
continuously monitored. The tests available are determined by the
vehicle manufacturer.
The Scan Tool does not perform non-continuous test, but
retrieves results from the most recently performed tests from
the on-board computer’s memory. You may retrieve non-con-
tinuous test results for only one test at any given time.
1. From the "Mode Selection Menu", use
the UP and DOWN buttons, as
necessary, to highlight Non-Continuous
Test, then press the ENTER/LD
button.
■ The “Select Test” screen displays.
The screen shows all tests applicable
to the vehicle under test. Refer to the
vehicle’s service repair manual for infor-
mation related to non-continuous tests.
If non-continuous tests are not
supported by the vehicle under
test, an advisory message shows
on the Scan Tool's display. Press
the ENTER/LD
button to
return to the Mode Selection menu.
2. Use the UP and DOWN but-
tons, as necessary, to highlight the
desired test, then press the ENTER/LD
button.
3. A “One moment please. . .” message diplays while the request is
sent to the vehicle’s on-board computer.
4. When test results have been retrieved, data for the selected test will
show on the Scan Tool’s display. The display shows the following
information:
■ Test ID number
■ Module ID number
■ Component ID number
■ Min or Max test limit
Only one test limit, either Min or Max, is shown for any
given test.
■ Test Value and status