Extang Encore Torno: 2014 GM Installation - Manual (Page 3)

With tailgate open, unfold tail panel
and press down onto truck bed.
Tonneau should now be
secure.
6
Extang Corporation, 5400 S. State Road, Ann Arbor, MI 48108, 734 677-0444, Fax: 734 677-8409
9
NOTE: To insure a
better seal, always
close panel before
closing tailgate.
Before this step,
be sure you
UNLOCK the
panel latch.
Unfold front panel and position
cab and middle panels over truck
bed making sure retaining hooks
engage pins in drain rail. Press
down on cab panel to lock in
place
10
Visit us at: extang.com
7
Lay EnCore cover back
over center of truckbed.
8
Secure EnCore tethers, located under
center panel, to each side rail. Tether
hooks must be attached to side rails
any time cover is on the vehicle.
Drill a 3/4” hole through a truck
bed knockout plug, truck bed or
bedliner. Insert the drain hose
through that hole.
Stand the bundled panel system on
the drain rails so that the retaining
hooks line up with the two pins inside
the drain channel as shown here.
Be careful not to
scratch the truck
finish at this step!