Fantasea Line Action 700 Video Light User Manual
Page 2
2
Fantasea BlueRay Action Video Light Instruction Manual 20121223
Identification of BlueRay Action Video Light Parts
LED Head
Power Switch
Battery Indicator Light
Hand Lanyard Insert Slot
Instructions for Use
A. Installing & Removing Batteries
a. Please read the following information and warnings prior to purchasing and installing
batteries inside the BlueRay Action Video Light:
i. Only 2 x CR123/CR123A 3-Volt Lithium batteries or a single 18650
rechargeable 3.7-volt Li-Ion battery should be installed inside the light.
ii. Installation of rechargeable CR123 Li-on batteries inside the light is strictly
forbidden, as this will burn out the light and may cause irreparable damage.
iii. If installing an 18650 battery inside the light, make sure that it features a
protective circuit board (PCB). 18650 batteries with a protective circuit board
are also known as 19670.
iv. Warning! Lithium-ion batteries can explode or cause a fire if they are used
incorrectly or if they are defective. Therefore, you are recommended to read
the following instructions very carefully:
1) Each time before using the battery, carefully check the battery and in
particular the protective seal/casing to make sure that it is undamaged and
intact. If in doubt, take the battery to a chemical waste disposal facility.
2) Always handle the battery with care. Never drop the battery!
3) Store the battery in a safe and dry place and keep the battery away from
all metal objects.
4) Never expose the battery to temperatures above 100 degrees Celsius.
5) Only use chargers that have specially been designed for use with lithium-
ion batteries.
6) When charging batteries, keep the charger away from highly flammable
materials or products and never leave the charger unattended when in
use.
7) Please follow the guidelines and restrictions of the batteries you purchase
in order to avoid any damage.
b. To open the BlueRay Action Video Light, hold the hand grip firmly in one hand with the
hand grip pointing towards your body and the LED head pointing away. Turn the LED head
clockwise until it separates. Pull the LED head off.
1
4
3
2
1
2
3
4