Fantasea Line BlueRay Extreme Video Light - Manual (Page 3)

3
Fantasea BlueRay Extreme Video Light Instruction Manual 20121206
d. Install the battery cartridge back into the body of the light so that the end with the
round contacts faces the LED head, while the end that features the power switch
faces the rear cap.
e. Re-install the rear cap on the opening, carefully aligning it with the thread on the
body of the light and tightening it evenly in a counterclockwise fashion all the way
to the end. Do not use force and do not allow it to screw down unevenly.
f. It is recommended to occasionally apply a slight amount of silicone grease to the
two black O-ring seals found below the threads of the body of the light prior to
replacing the battery compartment cover.
g. Install the hand lanyard on the light by inserting it through the Hand Lanyard Insert
Slot on the back of the light, then pulling it through itself and testing it in order to
make sure it is secure.
B. Turning the BlueRay Extreme Video Light On/Off
a. In order to switch the light on, push and hold the power switch button for half a
second. Take special care not to stare into the light beam or shine it into the eyes of
anyone else, because the light is powerful and could damage ones’ eyes.
b. In order to switch the light back off, push and hold the power switch button for 2
seconds. The light flashes 3 times and then turns off.
c. If the light flashes 3 times as soon as it is turned on and then automatically turns
off, battery is too low in order for the light to stay turned on. Follow section A on
this instruction manual in order to install fresh batteries.
d. Note that the BlueRay Extreme Video Light features 5 power output modes in the
following order: 100% power output, 50% power output, 25% power output, fast
flashing and SOS signal. Once the light is turned on, in order to switch between the
power output modes, simply push the power switch button. Each time the power
switch is pushed, the power mode is altered according to the order of power modes
as listed above.
C. Mounting the BlueRay Extreme Video Light on an Arm
a. The YS Mount included with the BlueRay Extreme Video Light enables mounting the
light on any arm or connector that features a standard YS Mount at the top, such as
on Fantasea Flex Arms.
b. Remove the screw from the bottom of the YS Mount by unscrewing it all the way
out.
c. Position the BlueRay Extreme Video Light over the arm so that the YS Mount on top
of the arm is aligned with the YS Mount at the bottom of the LED light.
d. Install the screw all the way through the YS Mount and arm connectors. Tighten it
enough to keep the LED light in a fixed position.
D. Care & Maintenance
a. After each dive, carefully soak and rinse exterior components in fresh water.