Audiovox XMAS100-UG002 - Manual (Page 14)

14
My XM radio is not receiving a signal. Use the “antenna aiming” feature on the XM ra-
dio and move the antenna to another location.
My XM radio will not turn on. Check whether the power cord is plugged into
the wall.
If applicable, make sure Auto-ON is enabled.
I only receive XM channels 0 and 1. Make sure your radio is activated. Contact XM
at www.xmradio.com or 1-800-XM-RADIO.
The radio and Sound System are on and receiv-
ing a signal but I can’t hear anything.
Remove the radio from the Sound System and
The minimum volume level is too loud or the
maximum volume is too quiet.
Adjust the line out level on your XM Radio.
re-insert it, then turn the power on.
Unplug any headphones.
Check the volume control.
Make sure mute is not set on the remote if
Make sure aux mode is off.
used.
I hear noise or interference. Move away from any cordless telephones or
electrical appliances or other devices that may
cause interference.
My remote doesn’t work. Make sure that the IR sensors are not ob-
structed.
It may be time to replace the battery in the
remote.
If this happens Try this
Troubleshooting