Hootoo HT-IP210F - Manual (Page 10)

Security Solutions Partner
10
Refresh Camera List, Flush Arp Buffer, About IP Camera Tool.
Figure2.0
2.1.1 .1 Basic Properties
There is some device information in the Basic Properties, such as Device ID, System Firmware Version,
Web UI Version.（Figure 2.1）
The Device ID is the camera ’s MAC ID (or Mac Address), which should be the same as showed on the
sticker at the bottom of camera. Every camera has its unique MAC ID.
Sometimes, if there is no IP address shown on the IP Camera Tool, it might be blocked by a firewall. Add the
MAC ID to the router, and give it a fixed IP or add the MAC ID as a trusted site. There are two MAC Addresses,
one is Device MAC ID, and the other is WIFI MAC ID.
WIFI MAC ID, you can find it from the sticker at the bottom of the camera, if this sticker is lost, you can login
your router, check the host status, which will show all the WIFI devices connected to this router, you can also
find the IPCAM
’s WIFI MAC ID there.
Figure2.1
2.1.1.2 Network Configuration
In this page, you can configure the Network parameter.