King of Fans Cressner - Manual (Page 7)

Hanging the Fan
REMEMBER to turn off the power.
Follow the steps below to hang your fan
properly.
NOTE: This fan is recommended for the
standard ceiling mounting using the
downrod provided with this fan. When
using standard ceiling installation with
an 12 inch downrod provided, the
distance from the ceiling to the bottom
of the fan blades will be approximately
18 inches.
THE FAN MUST BE MOUNTED WITH A
MINIMUM OF 7 FEET CLEARANCE FROM
THE TRAILING EDGE OF THE BLADES TO
THE FLOOR.
THE GLASS IS FRAGILE, USE CARE
WHEN INSTALLING THE FAN.
STANDARD CEILING
MOUNTING
1.
Remove the canopy ring from the
canopy by turning the ring to the right
until it unlocks (Figure 5).
2.
Remove the mounting plate from
the canopy by loosening the four screws
on the top of the canopy. Remove the
two non-slotted screws and loosen the
slotted screws. This will enable you to
remove the mounting plate (Figure 6).
Figure 5
Figure 6
3. Loosen the two set screws on the
decorative downrod pipe.
4. Route the wire exiting the top of
the fan motor through the decorative
motor collar cover then the decorative
downrod pipe and canopy ring. Make
sure the slot openings are on top. Route
the wires through the canopy and then
through the ball/downrod assembly
(Figure 7).
5. Loosen, but do not remove, the set
screws on the collar on the top of the
motor housing.
Figure 7
6. Align the holes at the bottom of the
downrod with holes in the collar on top
4.