Lokar Curved Aluminum Brake & Clutch Pedal Pad Cover User Manual
Page 2
INS0042 Rev. 01/21/14
Page 2
© 2014 Lokar, Inc.
Curved Aluminum Brake & Clutch Pedal Pad Cover Installation Instructions
Step 6: Attach the rubber inserts removed in Step 2 into the Lokar aluminum
cover using the adhesive supplied in the kit.
Note: Read the adhesive manufacturer’s instructions for proper
application. If excess adhesive gets on the aluminum, clean it off
with acetone before it dries. Apply a small amount of adhesive on the
aluminum pad only. Insert the rubber pad into the recess in the pedal
pad and apply pressure to the pad for 60 seconds.
See
Fig. 6 for a completed installation.
Hazards Identification: Irritant. Irritating to eyes, skin, and respiratory system. Cyanoacrylate. Danger. Bonds skin and eyes in seconds.
Ingredients: Ethyl Cyanoacrylate
Symptoms of Exposure: Vapor irritating to eyes and breathing. Prolonged exposure may lead to non-allergic asthma.
First Aid Measures: Ingestion: Ingestion not likely due to polymerization.
Inhalation: Remove to fresh air. If symptoms continue, seek medical advice.
Skin Contact: Soak in warm soapy water.
Eye Contact: Flush with water, seek medical attention.
KEEP OUT OF REACH OF CHILDREN
Additional Product Safety and Health Information Source:
Material Safety Data Sheet (MSDS RP, SI, FS, HT, & MG Series Cyanoacrylate Adhesive) or 1-800-255-3924
Fig. 5
Fig. 6
#8-32 x 1/2" Phillips Flat Head
Screws, With Nylock Nuts Hidden
From View