Lokar Throttle Pedal Pad - Manual

Stop! Please read all installation instructions before beginning installation. Call Lokar for any questions or
uncertainties during your installation.
WARNING: Disconnect the battery before beginning installation. Make sure the vehicle is in Park and at least
one tire is scotched to prevent the vehicle from moving.
Step 1: Remove the factory throttle pedal
pad from the throttle pedal arm. In
some cases this can be done with
the throttle pedal mounted in the
vehicle. Take the factory pivot pin
out of the plastic pedal pad. Remove
the pad, pin and spring.
Step 2: Remove one E-clip from the Lokar
pedal pin. Install the Lokar pedal pad
to the factory throttle pedal arm. In
most cases the spring and pin needs
to install on the right side of the
pedal arm, looking at the face of the
pedal. The spring should have the
hook facing down. Install the pedal
pin through the pedal back and
install the E-clip into the groove on
the end of the pin.
Photo 1
Step 3: Rotate the hook end of the spring up
to the top of the pedal pad and snap
it over the throttle pedal arm. Pivot
the pedal pad to make sure that it
springs back without any binding.
Photo 2
Throttle
Pedal Pad
Installation Instructions
Photo 1
Photo 2
Building American Quality… With A Lifetime Warranty!
10924 Murdock Dr. • Knoxville, TN 37932
TOLL FREE 1-877-469-7440 • (865) 966-2269 • FAX (865) 671-1999 • [email protected] • www.lokar.com
®
© 2011 Lokar, Inc. 04/18/11
Stop! Please read all installation instructions before beginning installation. Call Lokar for any questions or
uncertainties during your installation.
WARNING: Disconnect the battery before beginning installation. Make sure the vehicle is in Park and at least
one tire is scotched to prevent the vehicle from moving.
Step 1: Remove the factory throttle pedal
pad from the throttle pedal arm. In
some cases this can be done with
the throttle pedal mounted in the
vehicle. Take the factory pivot pin
out of the plastic pedal pad. Remove
the pad, pin and spring.
Step 2: Remove one E-clip from the Lokar
pedal pin. Install the Lokar pedal pad
to the factory throttle pedal arm. In
most cases the spring and pin needs
to install on the right side of the
pedal arm, looking at the face of the
pedal. The spring should have the
hook facing down. Install the pedal
pin through the pedal back and
install the E-clip into the groove on
the end of the pin.
Photo 1
Step 3: Rotate the hook end of the spring up
to the top of the pedal pad and snap
it over the throttle pedal arm. Pivot
the pedal pad to make sure that it
springs back without any binding.
Photo 2
Throttle
Pedal Pad
Installation Instructions
Photo 1
Photo 2
Building American Quality… With A Lifetime Warranty!
10924 Murdock Dr. • Knoxville, TN 37932
TOLL FREE 1-877-469-7440 • (865) 966-2269 • FAX (865) 671-1999 • [email protected] • www.lokar.com
®
© 2011 Lokar, Inc. 04/18/11