Lokar Brake & Clutch Pad For 1964 - 1970 Mustang User Manual

Lokar For the car

Advertising
background image

Building American Quality… With A Lifetime Warranty!

Step 6: Glue in the end rubber using the supplied 3M™ Glue in

kit.

Note: Read glue manufacturer instructions for proper

application. If excess glue gets on aluminum, clean it
off with Goo-Gone™ before glue dries.

Photo 5

Stop! Please read all installation instructions before

beginning installation. Call Lokar for any questions or

uncertainties during your installation.

WARNING: Disconnect the battery before beginning

installation. Make sure the vehicle is in Park and at

least one tire is scotched to prevent the vehicle from

moving.

Mustang Brake & Clutch Pad Installation

Step 1: Remove the stock rubber cover from the clutch or

brake pedal.

Photo 1

Step 2: Position the new Lokar aluminum cover on the stock

clutch or brake pad. Make sure pad is set on so that
the lip on the backside of the pedal is even all the
way around the pedal.

Step 3: We recommend using a transfer punch that is 3/16

in diameter to get an accurate punch mark for drill-
ing.

Photo 2 Note: If only a center punch is avail-

able, you can use it. However, be sure marks are
centered in the hole.

Step 4: Double check your marks. Remove pad and drill the

steel pad using a 3/16 diameter drill.

Photo 3.

Be sure holes are deburred before using supplied
stainless hardware.

Step 5: Set pad back on and use supplied 10/32

countersunk screws and nylocks and attach as seen
in

Photo 4. Note: Do not over tighten.

Continued on back page…

10924 Murdock Dr. • Knoxville, TN 37932

TOLL FREE 1-877-469-7440 • (865) 966-2269 • FAX (865) 671-1999 • [email protected] • www.lokar.com

1964 - 1970 Mustang Brake & Clutch Pad Installation Instructions

Part # BAG-6121, BAG-6123, BAG-6125,

XBAG-6121, XBAG-6123, XBAG-6125

1964 - 1970 Mustang Brake & Clutch Pad Installation Instructions

Part # BAG-6121, BAG-6123, BAG-6125, XBAG-6121, XBAG-6123, XBAG-6125

Step 7: The Lokar pads are now installed and will complement

the Lokar Throttle Pedal Assembly.

Photo 6

Photos 1 - 6

Mustang Brake and Clutch Pads

Photo 1

Photo 2

Photo 3

Photo 4

Photo 5

Photo 6

®

© 2006 Lokar, Inc.

Rev. 05/07 - RPD 07/29/09

Advertising