Lokar Throttle Pedal For 1967-1972 C-10 Chevrolet & GMC User Manual

Page 2

Advertising

Building American Quality… With A Lifetime Warranty!

1971-1972 Models:

Refer to Fig. 6 for the component names.

Step 1: Remove the original throttle cable from the vehicle.

Step 2: Remove the throttle pedal assembly from the inside of the

firewall.

Fig. 7

Step 3: On the new Lokar pedal assembly, remove the 1/4"-20 x 1/2"

flat head bolt and aluminum end washer from the pedal pivot
shaft on the left side of the pedal base using a 5/32" Allen
wrench. Slide the lower pedal arm and pedal pad off of the
pedal pivot shaft.

Step 4: Position the Lokar pedal base and upper pedal arm on the fire-

wall in the same position as the original throttle pedal assem-
bly. Install the supplied 1/4"-20 x 1-1/2" bolts using a 3/16"
Allen wrench.

Step 5: The Lokar throttle cable will mount into the square factory

throttle cable hole in the firewall. Install the throttle cable fire-
wall fitting into the hole in the firewall with the supplied bezel
washers (one washer on each side of the firewall). In some
cases it might require some trimming of the factory firewall
pad. Adjust the throttle cable firewall fitting so that it is in line
with the hole in the upper pedal arm. Tighten the adjuster nut
on the firewall fitting. Refer to the Lokar throttle cable instruc-
tions to complete the cable installation.

Step 6: After the throttle cable is connected to the upper pedal arm

and to the carburetor or throttle body, open the throttle to
wide open position and reinstall the lower pedal arm and pedal
pad so that the lower pedal arm is touching the floor. This
will ensure that the throttle is reaching the wide open posi-
tion at the same time as the throttle pedal contacts the floor.
Reinstall and tighten the 1/4"-20 x 1/2" flat head bolt with the
aluminum end washer onto the pedal pivot shaft.

Fig. 8

NOTE: Check to make sure that there is no binding of the cable
at both the pedal and at the carburetor or throttle body before
starting and driving the vehicle.

10924 Murdock Dr. • Knoxville, TN 37932

TOLL FREE 1-877-469-7440 • (865) 966-2269 • FAX (865) 671-1999 • [email protected] • www.lokar.com

1967-1972 C-10 Chevrolet & GMC Throttle Pedal

Installation Instructions

1967-1972 C-10 Chevrolet and GMC Throttle Pedal

Installation Instructions

INS0056 Rev. 11/14/12

Page 2

1971-1972 Models Only

1/4"-20 x 1-1/2" Socket

Head Bolts

1/4"-20 x 1/2" Flat

Head Bolt with

Aluminum End

Washer

Pedal Pad

Lower Pedal Arm

Pedal

Base

Pedal

Pivot

Pin

Upper

Pedal

Arm

Bezel Washers

Felt

Washer

Fig. 6

Fig. 7

Fig. 8

Advertising