MBRP UT5001 - Manual (Page 3)

UT5001 © 11/09 PAGE 3 OF 3
7. Set the T-Pipe Assembly at the desired height from the floor of
the bed (This will set the height of the Stacks). Using spacers to
hold the T-Pipe at the desired height, loosely attach the Stacks to
the Mounting Brackets making sure that they are straight. This
will hold the assembly steady while you line the system up to the
exhaust under the vehicle. Refer to Figure 5.
8. Measure from the T-Pipe slip joint to the exhaust system that you
are connecting to. Mark and cut the shorter side of the 20”x 14”
Elbow to the required length so that it lines up with the vehicle’s
exhaust system. Cut the vehicle’s exhaust system in a place
where the Flex Pipe can be placed between the exhaust system
and the 20”x 14” Elbow. It may be necessary to cut the 20”x 14”
Elbow again as well as cut the Flex Pipe. Refer to Figure 6.
9. Attach the 20”x 14” Elbow to the T-Pipe slip joint and then attach
the Flex Pipe to both the 20”x 14” Elbow and the vehicle’s
exhaust system. Be sure to slide the required Clamps over the
20”x 14” Elbow and Flex Pipe before connecting it to the
vehicle’s exhaust system. Refer to Figure 7.
10. Make sure that the Mounting Brackets are centered on the
Stacks and tighten the fasteners holding the Mounting Brackets
to the front of the truck bed. Tighten all of the Clamps making
sure that the Stacks remains properly aligned.
Congratulations! You are ready to begin experiencing the improved power, sound and driving excitement of
your MBRP Inc.
“Smokers Smokers Smokers Smokers™” ™” ™” ™”
. We know you will enjoy your purchase.
Figure 5
Figure 6
Figure 7