MBRP UT7001 - Manual (Page 2)

UT7001, UT8001 © 02/13 PAGE 2 OF 4
Installation of
MBRP
Inc.
“Smokers
TM
”
:
1. Measure 20” across from the inside surface of the passenger side bed
rail. Mark this location along the rail. This will be the approximate
centerline of the Stack once installed. Refer to Figure 1.
2. Using the Stack and the Band Clamp from the separately purchased
Stack Kit, slide the Band Clamp over the Stack. Wedge the Stack
Mounting Bracket (also purchased separately) between the Band
Clamp and Stack, adjust to the bed rail height and tighten the Band
Clamp slightly. Make sure the Stack is vertical, the Stack Mounting
Bracket is flush against the bed rail and centered on the measurement
made in Step 1. Trace a circle around the base of the Stack and center
punch the circle’s center. Verify that the center punch hole is in line
with your existing exhaust and adjust accordingly. This will be the
center line of your Stack.
3. Align the Stack centered on the mark you made in Step 2. Mark the
bolt hole location of the Stack Mounting Bracket onto the front rail of
the bed. Center punch the marks and drill holes to accommodate the
3/8” hardware. Refer to Figure 2.
4. Loosely attach the Stack Mounting Bracket to the front of the truck bed
using the 3/8” hardware supplied. Set the Stack up in the bed and
loosely attach it to the Stack Mounting Bracket. Make sure the Stack is
vertical and in the desired position. Refer to Figure 3.
Figure 1
Figure 2
Figure 3