MBRP S6012 - Manual (Page 3)

S6012 © 06/09 PAGE 3 OF 3
5. Install the Tailpipe from the rear of the truck, over the axle and
attach to the Muffler Outlet. Install the tail pipe hanger into the
OEM hanger; adjust for best axle clearance and Tailpipe exit
location to complete. See Figure 6.
6. Install the Hanger Clamp with the longest hanger at the
connection between the Muffler and the Tailpipe and into the
OEM rubber hanger at this position. See Figure 7.
7. Install remaining Clamps around pipes as shown in the
opening diagram. Adjust Tailpipe and check along the whole
length of the exhaust system to ensure that there is adequate
clearance around the spare tire, fuel and brake lines or any
wiring. If any interference is detected, relocate or adjust.
8. Make sure the exhaust is in place before tightening clamps.
Start at the front of the exhaust system and begin tightening all
connections.
9. Install and adjust the Tip to suit. Using a 17mm wrench tighten
lock bolt located on the Tip.
Congratulations! You are ready to begin experiencing the improved power, sound and driving excitement of
your MBRP Inc. performance exhaust system. We know you will enjoy your purchase.
Figure 6
Figure 7