MBRP S8102 - Manual (Page 2)

S8102 © 02/13 PAGE 2 OF 4
Removal of Stock System:
1. Apply a penetrating lubricant liberally to all exhaust fasteners, hangers
and rubber insulators.
2. Remove the exhaust system from the rubber insulators and remove all
of the clamps from the catalytic converter back.
3. Separate the slip joint behind the muffler and remove the tail pipe.
Next, separate the slip joint located behind the catalytic converter and
remove the muffler and extension pipe.
Installation of MBRP Inc.
“Smokers”
:
1. Loosely assemble the in bed portion of the T-Pipe Assembly (T-Pipe,
13” Elbow and 37” Elbow). Some models may require trimming of the
T-Pipe in order to accommodate the width of the truck bed and the
Stacks that have been purchased. Be sure to place the Clamps over
the pieces before they are assembled.
2. Place the Stacks onto the T-Pipe Assembly and place into the
desired position in the truck bed. The 37” Elbow should be on the
driver side so that the T-Pipe passes through the bed floor towards the
passenger side. Refer to Figure 1.
3. Place the Mounting Brackets between each Stack and the front of
the truck bed so that the Stacks are properly spaced from the front of
the truck bed. Center the Mounting Brackets on the Stacks and mark
the front of the truck bed in the center of the slotted holes in the
Mounting Brackets. Center punch the marks and drill holes to
accommodate a
3/8” Bolt (included with the Mounting Brackets).
Refer to Figure 2.
4. Loosely attach the Mounting Brackets to the front of the truck bed
using the 3/8” hardware supplied. Set the Stacks up in the bed and
loosely attach them to the Mounting Brackets. Make sure the Stacks
are in the desired position and the T-Pipe Assembly is level.
5. Mark the bed floor where the T-Pipe is resting. MBRP Inc.
recommends tracing around where the T-Pipe meets the bed floor.
Refer to figure 3. Remove Stacks and T-Pipe Assembly from the
bed of the truck. Find the center of the circle traced onto the bed floor,
mark and center punch it. Go under the vehicle and locate the center
punch mark. This marks the location where you are going to cut a hole
for the T-Pipe to pass through the bed of the truck. If you cannot find
then center punch mark use a small drill to create a pilot hole. Make
sure that there is clearance for the
14” Elbow to pass by any frame
cross members. Remove or modify any heat shields that there is
interference with.
Figure 1
Figure 2
Figure 3