Antec DARK FLEET DF-30 - Manual (Page 28)

28
4.4 R EAR E XHAUST 120 MM T WO C OOL ™ F ANS
There is one 120 x 25 mm TwoCool™ blue LED fan preinstalled at the rear of the case. This fan is designed to
pull hot air out of the case. Each fan comes with two-speed switch that let you choose the speed best suited to
your need. These switches are located at the rear of the case. The default fan speed setting is Low.
120 MM F AN S PECIFICATIONS :
Size: 120 x 25 mm TwoCool™ Fan
Rated Voltage: 12V DC
Operating Voltage: 12V±10%
4.5 O PTIONAL F ANS
There is one optional 120 mm fan mount on the left side panel. A fan can be placed here to enhance graphics
card cooling. We recommend using Antec 120 mm TriCool™ fans and setting the speed to Low. This fan
brings cool air into the case.
Speed
Input
Current
Air Flow Static Pressure Noise
Input
Power
High
1500RPM
0.30A
(max.)
1.43 m³ / min
(51.2 CFM)
1.21 mm-H
2
O
(0.05inch-H
2
O)
27.9 dBA 3.6 W
Low
900RPM
0.18A
0.84 m³ / min
(30.1 CFM)
0.49 mm-H
2
O
(0.02inch-H
2
O)
16.9 dBA 2.2 W
Note: The rear TwoCool™ fans have a two-speed switch that lets you choose between quiet or
maximum cooling.
Note: The minimum voltage to start a typical TwoCool™ fan is 5V. We recommend that you set
the fan speed to High if you choose to connect the fan(s) to a fan control device or to the
Fan-Only connector found on some Antec power supplies. A fan control device regulates
the fan speed by varying the voltage, which may start as low as 4.5V to 5V. Connecting a
TwoCool™ fan set on Low to a fan-control device may result in the fan not being able to
start because the already lowered voltage from the fan control device will be further reduced
by the TwoCool™ circuitry below 5V.