Amana Bottom-Freezer Refrigerator - Manual (Page 5)

A - 6
Installing Your Refrigerator
How to Reverse the Doors
Perform all steps listed in
How to
Remove the Doors and Hinges.
1
Transfer cabinet plugs and cabinet
screws to opposite side of cabinet.
• Remove cabinet plugs with flat
blade screwdriver tip wrapped
in masking tape.
• Remove center mullion screws
with hex head driver.
• For swing doors only
Remove bottom mullion screws
with hex head driver.
2
Transfer door stops from
bottom edge of fresh food
and freezer door to
opposite side of door edge.
• Use a Phillips screwdriver for removal and
installation.
3
See How to Install and Remove
Handles to remove and reinstall
handles.
4
IMPORTANT: When working directly on doors, place doors
on a nonabrasive surface protected by towels or rugs to
avoid damage to door finish.
Proceed to How to Replace the
Doors and Hinges to mount doors.
5
How to Install and Remove Handles
1
Remove top handle trim by
removing top handle screw.
• Retain trim and screw for later
replacement.
Removing Fresh Food Front-Mounted Handles
Removing handles may be necessary when transporting unit through
tight spaces, or when reversing the door.
Installing Fresh Food Front-Mounted Handles
If installing handles for the first time, the fresh food handles can be
located within the fresh food section. The handle trim will be located
in the literature pack.
1
Remove hex nut screws from
door face with hex nut driver.
• If reversing door, remove door plugs
from opposite side of door and insert
in screw holes.
Align handle holes with screw holes
on door face and secure with 2
door face screws from step 1.
2
3
Locate handle trim in literature
pack and install over top and
bottom of handle, as illustrated.
• Secure top handle trim with remaining
screw removed in step 1.
• Snap bottom trim over bottom portion of
handle.
2
Pry bottom handle trim from
handle with screwdriver flat blade
wrapped in masking tape.
• Retain trim for later replacement.
3
Remove two remaining handle
screws and remove handle.
• Retain screws for later replacement.
Installing Freezer Handles
If installing handles for the first time, the freezer handles can be
located within the freezer section.
Install handle by fastening with
screws removed from edge of
door.
• If reversing freezer door, remove door plugs from
top edge of door and insert into screw holes.
Removing Freezer Handles
Removing handles may be necessary when transporting unit through
tight spaces, or when reversing the door.
Remove handle screws with
Phillips screwdriver.
• Retain screws for later replacement.