Paragon 7105300 (Plastic Bowl) MAGIC SPIN 5 - Manual (Page 8)

8
MAINTANENCE PROCEDURES
SPINNING HEAD REMOVAL
Note: Head removal is only required for maintenance or severely clogged heads.
1. Be sure the MOTOR and HEAT switches are in the “OFF” position. (Cord should also be
unplugged from outlet.)
2. Remove plug button from the motor cover.
3. Align index mark on head apron with access hole on motor cover.
4. With a 1/8 ” Allen Wrench, loosen the set screw through the access hole.
Note: DO NOT remove the set screw.
5. Pull head straight up from motor shaft.
Note: For severe clogging, removed head may be inverted and submerged in hot water with a
mild detergent to loosen burnt sugar. Use care not to expose the underside of the head,
containing the slip rings, to moisture. Component should be dried completely before
reassembly.
SPINNING HEAD INSTALLATION
1. Align the set screw location with the FLAT on the motor shaft.
2. Lower head fully on motor shaft and tighten set screw through access hole.
3. Pull on head to assure correct seating.
4. Insert plug button in access hole on the motor cover.