Powerwinch Universal Strap Kit User Manual

Niversal, Trap

Advertising
background image

Powerwinch

Marine Products by Carefree of Colorado

1-800-621-2617

 www.powerwinch.com

056012-001r2 1 January,

2013

U

NIVERSAL

S

TRAP

K

IT

Kit Number:

Model Application:

Marine Product Kit

P91032

315, 712A, 912

RC23, RC30, PW2

Kit includes:

3" x 20' Strap with Hook (1) Strap Plate (1) Button Screw (2) Lock Washer (2)

The Universal Strap Kit is available for units with the universal spool shaft.

NOTE: Strap is rated for a working load of 2000 lbs. with a minimum breaking strength of 5500 lbs.

1. Extend the cable out completely and remove from winch.

2. Disconnect the power cable.

3. Remove the winch cover. Follow the directions in the service manual for the model winch being worked on.

4. Remove the level wind plate.

4.1. For models with a top mounted level wind plate:

4.1.1. Using a punch and hammer, bend the locking tab of the level wind plate down to clear the

mounting shaft.

4.1.2. Using a pry bar, remove the plate from the frame cross member.

4.2. For models with a bottom mounted level wind plate:

4.2.1. Remove the screws or drill out the rivets from the bottom of the frame.
4.2.2. Remove the level wind plate and reattach any components that were previously attached

with the plate.

Bend Tab

Down

Pry Plate Off of

Crossmember

Spool

Remove Level Wind Plate

Remove Screws

or drill out Rivets

Remove Level Wind Plate

Spool

Remove Covers

Remove Cable

Spool Shaft

(ref)

Strap with Hook

Strap Plate

Lock Washer (x2)

Screw (x2)

PW0012

5. Rotate the spool shaft to place the flat side up.

6. Slide the strap plate into the open loop of the strap.

7. Attach the strap and strap plate to the spool shaft using the two (2) screws and washers as shown.

8. Reattach the covers.

9. Wind the strap onto the cable spool. Ensure strap winds over the top of the shaft and is flat and even.

CAUTION

The fasteners on these winches are not designed to hold rated loads independently. Always

leave a minimum of 3-5 wraps of strap on the drum to achieve the rated load values.

Advertising