Pypes Performance Exhaust SMC22 - Manual

SMC20 / SMC21 / SMC22
Stainless steel cat-back exhaust system for
2009-11 V8 RT, V8 SRT8 & V6 Challenger
SMC20: 2009-11 V8 RT CHALLENGER 2.5” CAT-BACK
SMC21: 2009-11 V8 SRT8 CHALLENGER 3” CAT-BACK
SMC22: 2009-11 V6 CHALLENGER 2.5” CAT-BACK
1. Begin by placing the vehicle on a lift or four jack
stands at maximum height. This will aid in an easier installa-
tion.
2. Unbolt your existing system starting from the factory
catalytic converter down-pipes. Loosen the flanges at the
manifold to allow slight down-pipe adjustments. The original
system should come off the vehicle in two pieces.
3. Once the original system is removed, V6 owners will
need to install two rear hangers on the driver side in the fac-
tory drilled locations, some vehicles may not have threaded
holes from the factory. If so threading is necessary. Also
install new rubber insulators on the 4 additional hangers
already mounted to the vehicle. Also a new rear lower dual
exhaust cutout valance must be purchased from your local
Dodge dealer, p/n 6803950AB. The approx. dealer cost is
$55.00.
4. It’s time to install your new Cat-back system. Begin
by installing the two band clamps on to the after-cat x-pipe.
The x-pipe will install with the arrow pointing forward. V6
owners use part #HVC25,(the balance of the system will be
HVC21 clamps), V8 RT owners use HVC21 and SRT8 owners
use HVC24. Snug the clamps but do not tighten yet.
5. Now install the two mufflers with band clamps, snug
but do not tighten.
6. Next install the new one piece tailpipes into the rub-
ber insulators.
7. Slide the tips on to the tailpipes with a band clamp
and snug.
8. Finish by making all the final adjustments to the sys-
tem and tips. Tight all clamps.
9. Check all the connection points periodically, as they
may come loose.
Now it’s time to fire up that muscle car and enjoy your
new Pypes Performance Exhaust.
Pypes Performance Exhaust
2705 Clemens Road Bldg 105A Hatfield, PA 19440
800-421-3890 (voice) 267-638-3507 (fax)
www.pypesexhaust.com
(A) X-pipe Assembly
(B) Mufflers
(C) Tailpipes
(D) Tips
(A)
(B)
(C)
(D)
Thanks again for purchasing your new stainless steel Pypes Perfor-
mance Exhaust 2009-11 Challenger Cat-back system. Please be
sure to confirm all the components in the kit were received in your
shipment before beginning installation. If you find any components
missing, please contact our office at 800-421-3890 for replacement.
Installation of these kits will require a few simple tools: jack stands,
13mm & 15mm wrenches, cutting device and penetrating oil. For a
quicker and tighter installation, air tools are recommended. Techni-
cal assistance is available both online at www.pypesexhaust.com or
800-421-3890.
(C)
(B)
(D)