Pypes Performance Exhaust SMC12 - Manual

SMC10/ SMC11/ SMC12
Stainless steel cat-back exhaust system for
2005-08 300 / Charger / Magnum
SMC10: 2005-10 V8 300/Charger/Magnum 2.5” Cat-Back
SMC11: 2005-10 V8 300/Charger/Magnum 3” Cat-Back
SMC12: 2005-10 V6 300/Charger/Magnum 2.5” Cat-Back
1. Begin by placing the vehicle on a lift or four jack
stands at maximum height. This will aid in an easier installa-
tion.
2. Unbolt your existing system starting from the factory
catalytic converter downpipes. Once the original system is
removed, V6 owners will need to install two rear hangers on
the drivers side and also install new rubber insulators on the
4 additional hangers already mounted to the vehicle. Also the
rear bumper cover must be trimmed using the template to
allow the 4” tips to exit.
3. It’s time to install your new Cat-back system. Begin
by installing the two band clamps on to the after-cat x-pipe.
V6 owners use part #HVC21 and V8 owners use part #HVC65.
Snug the clamps but do not tighten yet.
4. Now install the two mufflers with band clamps, snug
but do not tighten.
5. Next install the new four piece tailpipes into the
rubber insulators. Notice that the pipes that connect to the
mufflers have only one hanger and the rear pipes have two
hangers. Remember to use a band clamp at the center joint.
6. Slide the tips on to the tailpipes with a band clamp
and snug.
7. Finish by making all the final adjustments to the sys-
tem and tips. Tight all clamps.
8. Check all the connection points periodically, as they
may come loose.
Now it’s time to fire up that muscle car and enjoy your
new Pypes Performance Exhaust.
Pypes Performance Exhaust
2705 Clemens Road Bldg 105A Hatfield, PA 19440
800-421-3890 (voice) 267-638-3507 (fax)
www.pypesexhaust.com
(A) X-pipe Assembly
(B) Mufflers
(C) Tailpipes (front)
(D) Tailpipes (rear)
(E) Tips
(A)
(B)
(C)
(D)
(E)
Thanks again for purchasing your new stainless steel Pypes
Performance Exhaust 2005-10 V6/V8 300, Charger, Magnum Cat-
back system. Please be sure to confirm all the components in the
kit were received in your shipment before beginning installation. If
you find any components missing, please contact our office at 800-
421-3890 for replacement. Installation of these kits will require a few
simple tools: jack stands, 13mm & 15mm wrenches, cutting device
and penetrating oil. For a quicker and tighter installation, air tools are
recommended. Technical assistance is available both online at
www.pypesexhaust.com or 800-421-3890.
(C)
(B)
(E)
(D)